Category
Microphone Accessories
Pop filters, windscreens, shock mounts, XLR cables and preamps that get the best out of your microphone.
12.950 KWD
or 4 × 3.238 KWD with
79.000 KWD
or 4 × 19.750 KWD with
WITH CARD
12.500 KWD
or 4 × 3.125 KWD with
WITH CARD
37.000 KWD
or 4 × 9.250 KWD with
WITH CARD
10.500 KWD
or 4 × 2.625 KWD with
WITH CARD
26.500 KWD
or 4 × 6.625 KWD with
WITH CARD
24.000 KWD
or 4 × 6.000 KWD with
WITH CARD
Showing 12 of 24 products
MIC ACCESSORIES AT AX
Finish the chain properly.
Pop filters, windscreens, shock mounts, Cloudlifter preamps and Klotz XLR cables that take plosives, noise and hum out of your recordings.
A pop filter or foam tames plosives, a shock mount keeps desk knocks out of the signal, and a Cloudlifter adds clean gain for quiet dynamic mics like the SM7B. Check the fit against your mic model.
Pop filters
windscreens and foams
Shock mounts
isolate desk knocks
Cloudlifter
+25dB of clean gain
MICROPHONE ACCESSORIES FAQ
Before you buy.
Straight answers to the questions we hear most about microphone accessories.
Pop filter or foam windscreen: which do I need?
Both reduce the bursts of air from P and B sounds. A foam windscreen such as the SHURE RK345 for SM7 models fits over the microphone itself, while a pop filter like the Elgato Wave Pop Filter attaches in front of it. Mic-specific options, such as the On-Stage pop blocker for the RODE PodMic, give the cleanest fit.
What does a shock mount do?
A shock mount suspends the microphone on elastic or rubber mounts, so desk bumps, typing and boom arm movement do not reach the recording as low thumps. Universal mounts are sized by mic diameter, like the Gator Frameworks 42-48mm and 55-60mm models, while the Elgato Wave Shock Mount is made for Wave microphones.
Do I need an extension rod for my mic stand?
An extension rod lifts the microphone higher on its stand, so it sits closer to your mouth without you leaning in. The Elgato Wave Extension Rod is made for the Wave mic stand, and the SHURE A26X adds a 3-inch extension to desk stands.
Is an isolation shield useful in an untreated room?
An isolation shield, such as the TONOR or Aokeo models, wraps behind the mic to reduce the echo and reflections it picks up. It helps in bare rooms, and placing the mic close to your mouth and adding soft furnishings or acoustic panels makes a clear difference too.